Recent content by mikers

hi i have got my 12ht rebuild I would rebuild my turbo but that can not be obtained spare parts as seen here in sets supra compressor housing and impeller i have such a turbo on hand nut wont buy it if it dosent fit but I can put the compressor wheel and housing just above the ct26 from my...

My plan is machine a gear to bolt between transfer and front drive shaft?

I kill my front pinion bearings If i put my diff opside Down and make a gear that turn my front shaft other Way Then it Will work Hope you understand mé

Hello I have stuffed longfield 30 spline in my hj61 front axle made ​​fully bulletproof except my ring and pinion gear the problem is the drive on the wrong side? I looked a little on the ring and pinion gear I have and can see it puts pressure on the small tapered bearing 'm on and...

hi my idle up actuator was srute solid. gave it a little oil so it worked again but the two rev up to about 1000? where to go around 600? eh could be wrong car is a hj 61

hey with you will just presents myself I am a boy of 19 years living in Denmark I bought a toyota land cruiser hj61men it is a little rusty in the chassis frame Today I make a couple holes on the frame and for fun I cut a square out a place where it was not so bad but I find it temlig rusty...