lelandEOD's latest activity

Welcome!

Hi, Western WA State here, I’ve owned my rig since 1999 and still loving it.

Damn. Two hours too slow!

Yes, that's the right one.

I think this is the one you'd be after if you are keeping the auto transmission. Toyota 16400-17031 (1640017031) RADIATOR ASSY - https://www.amayama.com/en/part/toyota/1640017031. The manual one is available too. Kurt at Cruiser Outfitters...

I'm going to keep the cross over, But I am probably going to remove the internals of the intake heater for more flow. It does get pretty cold here in Colorado but she'll be kept in my garage 99% of the time if I'm home, so shouldn't be an issue...

I also got around to installing my @Delta VS tailgate storage panel. I covered it in SeaDek foam and carpeted the inside with some light colored carpet so I can see what's in there. The SeaDek is pretty nice- just hoping Dave from Delta makes the...

I'm going to take a moment and make a comment for the benefit of anyone experiencing a similar issue. Ok, I've had a transmission-related vibration pretty much since I finished the conversion. The symptoms were a very noticeable vibration when...

Love my quad setup too. Just make sure you guys running LEDs find something suitably heated if you drive in the snow.

Well somebody had to be the guinea pig....and over a year later here we go. Got a bad case of cool parts envy on the Rubicon with @lelandEOD and ordered my @Delta VS tailgate panel. Also ordered a sheet of SeaDek and gave it a go. Final...

One would have to be nuts to swap an A750F for a H15x. I know it's personal preference but I have both combos and there's no question which one is better for 95% of the driving I do. If you do, I want that unused A750 for a spare. 😆

Small update here, did the timing belt, water pump, tensioner, cam pulley and t-stat last night. She should be ready to roll. :cool: Oh and I carved out what seems like a pound of very fine dried silt from the back of the fan pulley and from the...

I believe I finally settled on a 70 series solid axle oil pan. Those tend to be available but lack the oil level sensor bung on the side of the pan. I eventually compromised and just went with the 70 series pan rather than waiting for a good used...

Awesome work, looks like you’re cruising along. I’ve seen multiple recommendations for someone known as thraslux on the FB swap page for harnesses. Is this the same person as mick? Also, I did a brief search on partsouq and it wasn’t looking...

Stopping here tonight, have a few more connectors to unhook on top of the trans, and maybe pull the transfercase shifter. I also ordered the FT airbox lid, and I have a lead on an ft oil pan and pick up as well. Ive been debating if I just...

Thanks to a member sending me a link to this thread! The Window Rocket is my product. I'll start by answering a few questions- Austin didn't do anything sneaky in his video. He's a stand up dude and calls it like it is. I told him about the...

I have an oil pick up tube. PM me.

You will want a RHD gas pedal assembly. The LHD part does not play nice with the 80-series firewall.

@lelandEOD upon further inspection, it actually is a 1" lift.

Totally can

Can you make these out of clear acrylic instead of tinted?

Added this ram ball to where the seatbelt attached to. Available on the site now. Great place for me to have a charger from @Delta VS Rear marker replacement, i have a habit of breaking them..it has a red led. You can also go blank...

You could just swap out the 2 inch lift for a 1 inch lift. That's what I have on my truck and I have no problems with fan/radiator clearance.