Recent content by kewlaidjams

I'm pretty sure LX/LC are identical underneath/body wise.

I made a rear base plate for my LX570 few years back out of marine plywood, and recently removed it to put rear seat back on. Will be trading the LX for R1S s00n. Plate is free (12 pack of your favorite import beer wouldn't hurt) for anyone interested, pickup in the Houston metro area. See my...

Fry's has it on sale all the time with promo code. It was $8, I bought 4 of them few months back, and ATM have no idea where the other 3 unopened ones are.

Here's my cheap Fry's special hatch light

Cover Tie downs

Carpet removal basically just need to pull from any corner. You do need to remove both seats as the mounts do go between some of the cutouts on carpet. The factory carpet has about 3/4-1" of foam and other padding materials underneath which I removed so replacement of that material with the...

Wasn't 100% accurate with the tracing but close enough that it fit without issues. To mark the bolt locations, I tied a string to a random spot and marked each bolt position with tape and did it for every location that needed to be drilled. Once the string had 7-8 tape markings, the plate went...

I suspect the bolt mounts would be similar in the 2nd row and 3rd row version of the suv. Wouldn't make much sense for Toyota to change that much to the body structure vs simply hiding them with plastic molding for 2 row only versions. Lift your 2nd row carpet up and compare it to the bolt...

The Goose Gear plates are model specific from what I can tell/see. So you'll need the LC200 version of their product. I have two National Luna fridges (52L & 60L) and based on how your SnoMaster looks, it's very similar in exterior design.

More screws, I will add additional ones to free slots whenever I make it back to Home Depot. Done for now, temporary straps while I wait for a fridge cover.

Test fitment of seat Plate fully bolted down Carpet back on My Tembo Tusk slide with another plate added (originally bought for a NL 52L weekender but I'm putting a 60L in so it's 1" too long). Had to raise it. Bolted to the seat latch

Purchased an LX 570 few months back (after a decade with 2 Gwags) and have been considering some type of base plate. Looked at a Goose Gear plate but didn't really want to lose both 3rd row seats (still keeping one as daughter likes to occasionally sit back there) and also wanted it to look...

PM sent

Replied.

New here and looking to get a decent FJ62 (preferred) or FJ60. As usual rust free, no transmission issues etc FJ. Must be clean inside as wife/kids will be along for the ride. Budget is 10k or under. Prefer a Texas FJ but I'm willing to fly and drive a FJ back within 1000 miles of Houston...