These are used, but in near-new condition. I found them in my garage rafters while cleaning up. They’ve been stored for years. I no longer own the FJ 62, so little by little I’m clearing out old stuff that I’ve stashed. Asking $75 for the pair, but make me a reasonable offer and they’re...
It’s a light grey/beige? Just like you see in the picture. Don’t know much about the fabric, see the pic. Again, it’s a Noah cover, I don’t think they sell them any more. The last cover I bought for my Bimmer was similar, but thicker. Really too thick. I preferred the Noah.
Not sure If I...
This is a California Car Cover for a FJ60/62. I believe it’s a ”Noah”. It’s in excellent condition, like new except for some minor soiling. The elastic is still good, no tears. I hardly used it, it’s been stored in my garage for a couple of years. I put a RTT on my truck right after I bought...
We never made it to Tuk. We only got as far as Engineer Creek. Weather was bad, smoke from fires and then rain, which made the drive up to that point miserable and slow going, also because the rain make the road pretty bad with potholes. So we bailed, and spent more time in Anchorage. We’re on...
Gonna do it again. Leaving Jul 4. We’re taking the ferry from Bellingham to Skagway on the way up. On the return, we’ll be going over the Top of the World Highway into Anchorage. From there, we’re doing a guided base camp trip through Alaska Alpine Adventures to the Bering Straits National...
Yeah, I might do that. I probably should have done more research before buying the FTM-200D. Chirp software doesn’t work with it. Not sure If I have enough time to figure out alternatives. It’s pretty tedious to manually input them.
Recently got my Ham Radio License and installed a Yaesu FTM-200R prepping for a road trip to Canada and Alaska. Bought a Yodateq Antenna Mount. Very nice!
I just installed my TorFab LEDs with the 4 low beam option. Works great! However, I can confirm that they don’t work with the SLCFJ62 Harness. I just unplugged it and hooked up the lights to the original wiring. I’ll fish out the unused harness next time I’m mucking around in the engine bay...
Yeah, I know it’s overkill, but no way am I going to yank out the harness and go back to the original. I’m thinking that it should work, I mean the purpose of the harness is to use relays to keep the heavy current out of the switches, right?