Recent content by jk080

Welded up the gaps, let cool, replaced the seal and good to go.

First I had to find out where to bend and with using the Portaband bandsaw (the best tool ever). I made two cuts down the top gusset where I wanted the bend. A few on the bottom gusset to allow some room. Then I wrapped a big chain around the knuckle and up around the ram mount over the...

I have been in the process of upgrading my front axles from 27 spline longs to 30 spline and while I was there I would clean, replace all seals and new studs for the high steer arms. I also reinforced the knuckle (because it likes to bend there) with a new shock mount from Marlin. I noticed...

The way I found these two calipers was to Goggle Tacoma rear caliper. I am not familiar with the Tacoma to know if these are correct. Yea I thought the four piston would be overkill

I have this bracket from Ruff Stuff This is for a rear disk brake conversion on a 85 Toy Xtra cab And this caliper, they don't fit together without modification, I cant seem to be able to get through to Ruff Stuff and ask them why. There site says all you need is to use the Tacoma caliper...