I... I just can't. This thread is currently sitting just above @aztoyman's thread. He's hand-making parts, re-engineering fuel and cooling systems... He's probably got GA Tech and MIT engineering grad students stealing ideas for their theses. In...
This weekend I spent doing little things. I’ll change some connectors to Deutsch. I’m missing the mating connectors to some harnesses and have unlimited supply of all Deutsch products. Also a $1500 crisper that kept after a project ended...
You will need to cut the small wiring harness for the switch and license plate lights.
Install your favorite 3 wire connector set on the harness and switch assembly. Please note that the connector on the switch needs to be able to pass through...
So I pulled the Idle Air Control Valve out. It ohmed right where it should be on both sides.
I threw some wires on a deep cycle battery and cycled the IAC. It was dirty, but it closed fine. Switched to open it and it didn't open all the way...
only you can answer the question of is it worth doing. really depends what you want from it.
but the cummins powertrain is excellent. if you shift your trip focus away from wheeling and more towards cruising and hauling especially. i wouldn't be...
FWIW, my tool batteries definitely struggle below zero (celsius) and will only charge above zero. I bring them inside to charge. I have Makita tool batteries and Ryobi snow blower batteries. I have not tried jumping with either, but...
The engine build has finally started and it feels amazing.
I tie the bottom end apart, cleaned it all and put it back together with engine assembly lube due to my concerns with the rust being present on the deck. I did get the balance shaft...
I've been busy with the "homework" but I got a few hours the other night. I noticed some factory holes in the top of both frame rails and I was surprised at how thick the frame is there. So I drilled them slightly larger and installed threaded...
96 HILUX LN112 checking in from Virginia. JDM RHD.
Really hoping to get some relevant comfortable model numbers for bumpers and body work.
Not easy to find Hilux-specific accessories, but millions of Tacoma options. 🥴
3 Doors are in.
Check for fit of the dash and steering brackets. I don't really remember how it all goes together. Puzzle.
Also windows are checked for fit.
Insulation 3 layers are next.
I still not clear how to attach the fender flares. Hate...
Made it home safely after 17h of driving at 50-60 mph. Rig did over 24mpg until it lost 10 gallons on the freeway on the return line. Took 10 min to fix. I think it is a defected hose because the other section of the line has been there for 20...
Tomorrow headed back to the Bay Area with the body and doors towed on a trailer with our 60. Storm weather. Be exciting.
Can’t wait to mount this on the frame.
Finally after 24 months body is ready to be picked up. Every panel worked on or new OEM. NO RUST and all protected. Planning to drive down to Flagstaff and pick it up with our 60 series Landcruiser that just got a Toyota diesel engine from a...