Recent content by Gunso

Thanks Jerry, I was at the salvage yard and saw a Late 90's Dodge Durango with somethin similar. It looked to me like Dodge was the last to use the old thorttle bodies.

I was looking at options for a snorkel on a SBC and this is what looks like the best route. Spectre Performance 9849 4" Single Air Intake Plenum ~$100 on Amazon Anyone have better suggestions?

I put the old rear shocks in the front to save money. I think they are over 14" collapsed. I got offered some BDS socks for the front for free. 14" ers. I declined because my old shocks seem ok and I'd rather er on the side of long. For the rear I'm getting some 16" Monroe Gas for $27.99 each...

Thanks wrench. I have a micro torch. I'll give it a try on the other side. Then maybe I'll only have to buy 1 cylinder. There is so much rust in there I can't see how it functions at all. Maybe it doesn't. It seemed like every time I replace one thing I break another. Hopefully I'll be done...

Update: The lift is installed. Still got to do some brake work. The bleed bolts are locked by rust and now they are rounded. But somehow I still managed to open the line because fluid comes out now. Anyway here are some after shots. Going to change the wheels and take off the spacers in the...

I like your spacers. I have used something similar in the past to lower a transfercase on a 1987 GMC Fullsize Jimmy. That thing looked cool, but major problems. Never going back to one of those. I still have dreams/nightmares about it.

If you decide on PS, I recommend the Saginaw. I have factory PS and it isn't all that great. I might be upgrading to Saginaw in the future. If I had no PS I would definitely choose Saginaw over anything else. Far superior design and function. Also a LC factory PS box is $$$$.

Jim, where did you source those poly bumps. I like that setup. ...via IH8MUD app

Paved roads aren't the only ones in it's future. Hopefully I can use a longer shackle in the front. ~$80.00 from CCOT. Any suggestions on bump stops. Mine are almost finished. One is missing the rubber. I have it in a box in the shop. Another one is completely MIA. The two remaining do...

Fronts were ok? ...via IH8MUD app

X2 on the bench bleed the master cylinder. That was my problem on my '96 4Runner after I replaced the master. I had my kids out in the garage on several occasions "up"... "down"... "up"... You get the idea. I took the master back off and bench bled. Fixed it. ...via IH8MUD app

Careful, Jim, Claudia likes Skyjacker. ...via IH8MUD app

Thanks Jim. CCOT sells 1.5 and 2.5 inch over stock. I plan to keep mine in the front stock or buy whichever ones level it out the best. I'm hoping for the 1.5 inch. ...via IH8MUD app

I don't think that I'll have brake line repaired by then. I went to the meeting in November.