Recent content by giacomo

Hi, 1996 KZJ70 LHD with rear drum brake to which I would like to fit heavy duty rear axle shafts, but who builds them ? It seems to me that RCV doesn't have them and neither does Longfield can someone help me ? thank you Giacomo

Hello Juan, thank you for answer, but the lenght is : 1185,00 mm Giacomo

Hi all 2008 HZJ71 1HZ LHD , someone know the tie rod lenght ? should be approximately 1184,00 or 1203,00 mm ? thank you Giacomo

Too difficult and technical question ? can anyone help me ? thank you Giacomo

Hi all, 1987 LJ70LV- MNXW 2L-T, that finds it hard to start when the temperature is lower (12/20 °C), but when the engine is hot the start is immediate so I checked the entire pre-heating system and I have these results: 1 only glow plug relay ( but shouldn't they have been 2 ? ) which is ok 4...

Hi portcruiser and thank you for answer I think it's only for the EGR control, even if it has a sensor on the injection pump anyway I tried to write to Huber company but no response....

Hi, I also made the diagnosis with the Teachstream but for me it is unable to communicate with the control unit, as it even sees ABS/VSC/TRC and SRS Aibag ECU that the car does not have..... I really don't know which tool to use thank you

Ok, thank you a friend has the techstream, and i will try that too Giacomo

Hi all, does anyone know which diagnostic tool to use for a 2008 HZJ71 4.2D 1HZ ? after off-roading with lots of water and mud, the engine light suddenly came on, even though the engine runs very well..... thank you Giacomo

Hi, A : 566 mm B : 340 mm C : 330 mm Giacomo

" That is great news. I'm over hear thinking I need to pull the axles..... I assume the drive shaft comes off or is there enough space in the slip yoke? " obviously drive shaft comes off... Giacomo

yes, removing the other two supports and moving the front differential back, it is possible even if two bolts are removed with difficulty ... 41108-60010 Cover Front Differential Giacomo

I don't think this is the case, I know very well the cutting and welding that is done on the catalyst to empty it, but this time as I disassembled it myself and saw with my own eyes, (Fabio is a dear friend of mine) I can ensure that there were no cuts of any kind ..... Giacomo

Hi Noaly but you have mounted a lift kit and maybe the sway bar link have become short ? Giacomo

Bump up can no one help me ? thank you Giacomo