Recent content by Geoffrey Carter

Bought it back from collections and I'm finding all the missing parts that have been tossed about the shop.....

Price on 15x7 -20 wheels and would you ship to FL? 850-630-two one 74

Dead post, I ended up rebuilding my 2L. I have a complete 2uz for sale now.

I have a 2LTE and automatic transmission from 1992 LJ 78. Engine will need a rebuild and trans good. Best offer come pick it up.

I originally was going to go with the 1u but the engine and transmission alone we're just $700 minus all the extra bits that I needed. My plan is to go ahead and utilize the OBD2 port as well out of this truck to make diagnostics a lot easier. I will try to snap shots as much as I can. I've...

This is non vvti engine. Hopefully this goes smooth I'll keep you guys posted with a build thread.

One thing to keep in mind guys that I have actually bought a complete truck, I'm going to park them side-by-side and perform the swap that way so I'm going to have full access to everything.

I love the pictures, I really just wish they had some kind of description, but the all-important one that I can see is that the engine appears to be shifted about an inch to an inch and a half forward. And it's looking like he's piggybacking off the factory 2L ECU. My plan is to run a digital...

In the write-up on this site Postoy actually swaps his output shaft with the output shaft of the A341f but that was out of a two-wheel drive LS400 I think. I do know that a guy by the name of PradoCruiser was referenced a few times. This is about the best write-up I've seen so far with any swap...

So after better part of five months trying to save my 2LTE I've decided to do a 1uzfe swap, there's a couple of really good write-ups were people have been successful and I've tried to create my own little swap guide based on these posts, my only question is can I utilize the transfercase out...

After 2 months of waiting around my new head from "Australia" finally came in and was installed. The fit and finish is absolutely wonderful but now my PSI across the range is about 250 to 300. My vehicle also smokes worse than Snoop Dogg and Bob Marley and I have a s*** ton of blow by. Things to...

the casting on my OEM head had a small crack which was causing the bucket to rattle around which eventually fatigued the metal and allowed the bucket and shim to turn sideways and snap the timing belt..... the new cast head from down under by way of texas will be here soon. I'll take lots of...

A lot of the V8 guys seem to like them with their LS and other small blocks, there aren't too many negative reviews aside from parts needing to be sanded down a little bit further. I'm just hoping since this is a fully assembled piece but some of those precautions have been done already, my plan...

I know about the head swap, but I do not have the extra money for just the 3L head. I found a cast head from Australia fully assembled for under $400 new. I just need to get my truck on the road to get it home. I'm only cheap for right now. My security company is just getting started my start up...