New to me 1999 LC
First order of business is to replace fluids and suspension bushings. This will be my somewhat daily with some camping trips sprinkled in.
Hey guys and gals, after almost 4 years of ownership i figured it's finally time to start a build thread on it. For those that know me im a "everything has its price" kinda guy. I'll sell anything and I have a horrible obsession's with FB...
Considering that make and model of the wheels are mentioned at least 3 times in the article, (with hypertext links), and the rather large stickers on the back windows, I’m pretty sure someone can figure that out.
😂
Hey there!
I'm new here with a new to me LC, It wasn't the intention, but i couldn't be happier.
Me and my partner recently bought a house outside NYC, Catskills area, and are in the process of getting it up to date while slowly moving our stuff...
Tire and wheel upgrade time. Did the first round of tire clearance trimming. Will clearance this area better as time permits. We are headed out this Saturday and hoping to hit some snow.
Rear diff hose along E-brake line
You can see the red rectangle in the left of the image, this is where the e-brake enters the cabin. You can see where I zip tied the rear diff line to the transfer case line
A shot from the transfer case...
The infamous entry into Gunshot Creek, Cape York Aus.
It's a bit of a scary one! looks way worse in real life.
Near vertical drop with sharp exit at the bottom, at times, it's a bit of lottery if you can drive out of it.
Tossed the relatively inexpensive HF Badlands Apex 12k winch on the not-so inexpensive Slee blueberry bumper & fairlead. No room for the electronics so had to relocate to a Pelican case in the engine bay. Zip tied until a better mount is...
Been busy this week. Did Kings springs, new CV axles, front leather and finished installing the Dissent rear bumper. Feels like a new truck. Just have to relocate my backup camera and I am done for a while.
Finally got around to replacing the foam surround on my rear sub. I probably would have broken a few less clips of it wasn’t 20 degrees while I was removing the panels. Overall it wasn’t as bad as I was expecting and now I can add repairing...
My experience with our three 100's over many years is to just carry an OBD II scanner, a spare OEM coil or two, a decent set of tools including a flashlight. Its a failure mode that is not going to leave you dead in the water and it is a pretty...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.