Recent content by eric90503

Any idea of timeframe?

Nice, it was so clean I missed it in the original wide. I had that same one, until it snapped at the mount. Mine was probably a bad lot. Very clean indeed!

Nice, Glad you took a pic while it's clean. Do you have a pic of your Catch can set up? Let us know how you like it after break in. I like mine and although not a huge gain, it's a gain I'll take.

I can, but the shipping might make it not worth the trip. From my understanding these are NLA?

Get your spare trail alt!

https://www.densoproducts.com/denso-210-0181-remanufactured-alternator Selling LNIB Denso 210-0181 Alternator. Bought and decided to go Photoman/Landtank route. Local Pick Only 100 FIRM

Hope everyone is having a nice Labor Day weekend. I'm about to finally install my LRA 24 into my 80. Having tapped on this unit, the gauge steel seems a bit thin. My New Tank coming off the shrink wrapped pallet already had a nice silver dollar sized 1/8" deep ding in on the bottom. First...

Thanks for the recommends, ...but Yotamasters. There's a thread on them, a while back they charged me a few hundred bucks to diagnose a drive line vibration I couldn't figure out. I had an old landtank driveshaft a friend let me borrow for them to test. 3 weeks later after the shop personnel...

Miyaki is great! I have a 24g that needs some fab work to be able to be fitted. The 4x4 labs bumper needs a little mod to make it fit. Never had a chance to look at Miyaki's welds. Even though it's probably going to be a length of angle iron and tabs, I like clean welds, that hold.

Anyone in the SoCal area have any LRA tank installer recommends? Even though this takes half a day, just not enough time in the day. So it just sits. I've heard about RPM in Monrovia but don't know how clean their work is (Fab/Weld/Electrical). Any feedback is most appreciated!

I had to find one in a junk yard and pull one off a 2nd gen 4runner. Not a fan of wasting time at a junk yard. I know there's many ways to wire this (AC, manual, etc) What's the general consensus that people like in wiring this in?

When will your IC setup be available? Have you had a chance to test it? Looking forward to hearing your results.

Nice work! Any news on when your IC will be available for Magnuson owners? Btw, any ideas on how to mitigate the heat soak considering the IC is partially over the ex manifold? Thanks for the update.

Nice work! Already popped my NOS blower on. Any updates for your IC options for the TRD blowers? What do you anticipate your blowers to be at hp/tq wise over the TRD ones?

Forgot to mention, the oil seal after 14k miles (I replaced the spindle after the bearings 26k ago) did put a decent groove in the spindle surface. It did its job, hoping to migrate the new oil seal for a new lane. I don't mind throwing money at this rig, just trying not to waste it. I've...