Recent content by duneFJ40

Thanks for the replies. I think I will take it to my buddy's garage and use his lift. So, the parts I need... Main bearing seal oil pan gasket clutch disc and pressure plate throw out bearing> (Do they use those on this rig?) Thanks!

Yeap... never seen the seal. I just crawled under there last night to clean the oil off my floor. Looks like I'm headed for a "longer than an afternoon project". damn....

I'll take a picture.... The brake light is on the right (facing the dash). The light I'm talking about is opposite side and white? Thanks

the speedo gauge? It is a white light that just started going on and off? Thanks

out the trans? I did a search and some say you can remove the bearing cap and slip out the oil seal with the new. Is that the case or do I have to take the trans and TC out? This is for my 72 FJ. Thanks...

I have no idea where the sensor is located. I will dig around and see if I can post a pic with my findings...

The key was out of the ignition so it must be hot wired. I thought it was a pretty nice feature. If coolant is pouring out that fast then you are right, it's a bigger problem than the battery going dead!

I was draining the coolant this evening and once the level got to a point an alarm started to sound! Is this a stock set up or aftermarket? I do have a 110 plug in engine warmer that someone added at some point. Maybe that? Either way, I thought it was pretty cool!

Thank you guys!

For my 72 FJ40. It has been re-cored but I can't find any evidence of a drain plug. I did a search too... Thanks

I purchased the mount for the winch from Cool Cruisers for $89.00. It is a bolt on item and it fit well. The control box mounts to the light bar. I fab'd a bracket for the connection.

First add/mod to my FJ. It's the M8000. I was pretty happy with it.

Good point. I sometimes get carried away when it comes to cars. My shifter is on the floor so that's not an issue. I'm in process of hooking up my winch... That should tide me over for a while. Thanks

Thanks for the reply. I just checked out your winch mount on your website.... I see what the curved stamped pieces are for.. Pictures are worth a thousand words! Thanks

I am in process of mounting my new warn M8000 winch and was wondering how you guys mount the control box. I want to center it over the cable spool. There are two small bolts with nuts that come off the bottom of the box and two stamped "curved" pieces that are part of the steel bottom. I'm...