Devil's Slide Doug

Valley Hybrids or Cruiser outfitters could probably advise you/provide you with the right part. Obviously It depends on course verses fine spline and the correct bolt pattern. For example, personally if I re- gear my stock 71 course spline diffs...

Even I am not that cheap. I would replace it but I would use a speedi seal rather than machine it if the flange wasn’t available.

If you are registered then show up at the right place at the right time. I’m pretty sure Brian Flynn is leading the run.

Pretty sure that applying heat should help break loose red lock tight.

Guilty!

Thanks for the photos. Somethings collapsed a bit. My truck has been through the con and other trails and some high speed desert driving, all while heavily loaded. The bushings look a bit bulged. I'll take a closer look at the brackets on the...

I was halfway through the Rubicon trail and noticed that the bottom of my passenger rear door is rubbing against the top of my slider when I open it. I assumed the slider was bent up but I got home and took a look in the rear fender well and see...