My assumption was it was not working, since I have nev heard or seen it run,, mayb nev got hot enough? Have done drives this summer of 80 miles + on hot days, & as said I assume wire is fine,, if it works when attached to ground
Was up to getting the carb fan going on my 1988 FJ62, I had an extra relay & the fan relay under drivers side cowl looked pretty ratty so I switched,, no go, then after a little digging on ih8 I found that an issue is the wire that attaches to the manifold heat sensor burning out,, & that if u...
Got the new relay,, did nothing, today I took off the starter & found the un even wear on the contacts & replaced & new plunger,, started up,, no click 👍
I ordered a contact & plunger kit,,, & an ignition relay,, in the mean time after cleaning starter as good as possible prior to removal it seems that I am starting the truck easer than before,,, just not turning column switch all the way, if I do the quick turn all the way,, I just get the...
my daily driver 88 FJ62 has been starting & running like a dream for many, many months (mayb it was a dream) last week when i turned the key, I had nothing but a click, then would do again & it would start,,
after a week of this i went to start & nothing but a click,,, no crank,, I cleaned...
Does anyone know the correct ECM ECU for my 88 FJ62?
It has a 89661-60011,, & from what I am finding it should be 60021..maybe PO switched out, idk
Would either work in a 88?
I am thinking of getting replacement to solve a check engine light that will not reset or show a code
Thks
I am going over the bottom of my fj62, a little bit here,,, & little bit there, mostly taking off frame surface rust & painting with Eastwood rust encapsulator, I tinker, but am no mechanic,,
Can any one tell me what this apparatus is next to the park brake cable at rear axel? Is it part of 4 wd...
Getting ready for my 1st oil change,, ordered a filter through Toyotapartsdeal ,, item # checks out #90915-YZZD3 but this is smaller filter than Iam used to,,, & truck currently has a full size fram filter on it,, this thing is 3”dia 4” long
Threads look the same,,
Is base able to take smaller...
Drove to work with hubs locked, in 2WD,,no noises, put it in 4wd in a gravel parking lot & seemed to b working fine 😅
Next I am going to spray some pb blaster on the 4L shifter linkage, clean & lube & hopefully get it shifting,, if not I’ll b satisfied with 4H till I get it on a lift to look in...
Got the seals & gaskets did a better cleaning of the hub dial assembly, put back together, & its working correct 😃👍,,, only note I would mention is to look carful & make sure position is correct when putting on,, it seems it could go together in wrong position where clutch can not slide back...