I'm FWDV (Four Wheel Drive Victoria) accredited, not sure the I4WDTC accreditation has caught on on this side of the globe as yet. Looks like the thread has taken off, well done.
Simon
Subscribed, I'm an accredited 4WD instructor from Australia, I learn a lot from other instructors to help my students. Looking forward to your posts.
Simon
You'll need a h1fa transfer case, these are factory part time cases and come on the Australian Standard and RV models (the one's with barn doors)
The PTO drive that bolts to the side of the transfer is very rare, even in Australia, I imported mine for Japan. not cheap...
Simon
Nice, better instalation than mine with the same recovery points from lukey's 4x4. I used the original captive nuts and new grade 8 bolts.
well done
Simon
I've got a set bolted to the front of my 80, three bolts give me more confidence for snatch strap recoveries than two. These are the only ones on the market I could find that used 3 bolts. Great Aussie made product.
Simon
I think the freight company took the senic route down here :rolleyes: (Melbourne Australia) Picked up the kit from the wharfs today. Can't wait for the rain to stop down here so I can get stuck into it, I've already got the winch ready to drop in....
thanks again
Simon
1 Dual swingout with winch, twin tyre carrier + 3 gas can kit. heading downunder (Melbourne, Australia) thanks for organising the group buy.
I owe you a beer :beer:
thanks mate
Simon