Recent content by bambuhiphop

Looking to get some parts up to the Seattle area. Includes a 3FE head and a bunch of engine parts. Anyone making that trek that has some room?

Bump for a price drop. Asking $400.

I'm not 100% but I want to say less than 120,000. It came out of an 88' 62 that lived in Palm Springs its whole life. It was a very clean engine.

bump, lookin for a good home.

I have just about everything needed to turn that 2F engine in your FJ60 into a 2FE. This is a good opportunity to get everything you need to do this conversion. Have doubles of some of the parts. If you would like any more information or pictures please let me know. More than happy to share...

Not sure if it is the bearing or if it is from the clutch being adjusted incorrectly. It has been doing it for awhile and stopped briefly when I replaced the master cylinder but I didn't have time to adjust that fully so I think that is what is going on.

I could get the truck to the San Jose area but not any further I'm afraid.

@bean - pm your email and I will get some pics together for you.

Bump again -- Asking $2,000. This is a good truck. No Rust. $2,000 takes it!

Bump for price drop.

Sorry, posted in wrong spot. Already re-posted in correct place. Mods please delete this one. Sorry again.

--- Dropping price to $2,000 --- So the truck has about 264,000 miles on it. Engine has 33,000. It was replaced by the original owner back in 2001. It was a SOR motor which came from Japan. It needs some work but I drive it daily. Life is leading in a new direction so we have to part ways. -...

So the truck has about 264,000 miles on it. Engine has 33,000. It was replaced by the original owner back in 2001. It was a SOR motor which came from Japan. It needs some work but I drive it daily. Life is leading in a new direction so we have to part ways. - Bit of a squeak at idle - Engine...

Ya, I recently replaced all the horn components and this issue didn't start for some time after. I guess I will open it back up and see what is happening.

They are Goodyear 31x10.50P15LT tires. It is the stock suspension. Little saggy but not to bad. Thanks on the rims. That was one of the reasons I bought the truck. So far as I tell they are color matched to the truck paint.