I've had it running for about 9 months or so with no issues. I swapped in a '08 5.3 so I plumbed the regulator/filter in tank as well. The hole/bung is big enough that all of that just barely fit in on one shot into the tank. The pump in the tank keeps it quiet. My original idea was to weld...
You are welcome Mike.
You are miles from having to worry about the suspension. Get the motor and drivetrain in with the tub on. That should be damn near running before you even start to screw around with the suspension.
Pick your battle and finish it before you start another. You have...
Mike,
Put the drivetrain in it first. Then do the suspension. Good prep work is the key. Use good jackstands.
I can't remember... didn't you get the Proffit SOA kit? If not, here is how I did mine:
1) Prep the front housing by cutting/grinding off all the existing spring perches...
I am not sure what help I can be other than I had my 465 apart several times recently and went through the t/case as well. I could not quite tell if you said the noise and vibration came while it was in neutral and stopped? Does the noise occur while in all gears or only in third? (also, is...
No help from me Joe.
It seems to me that 2.65mm is a lot - but don't take that for anything.
Did you do the other side? See what the other side does.
Andy
Toyota of Seattle said there was no possible way they had that part. I sensed he was chuckling on the other end. He didn't even bother to check for part numbers for me.
The parts counters at the dealers around here suck.
Thanks Cruiserbrett.
I picked up a 3 speed case from a friend and pulled the Idler gear and shaft and installed them in my case. Here is what I found:
a current gap of .024 with an acceptable range between .004 - .016.
The manual says there are spacer options:
.047/.051
.051/.055...
Thanks for the replies, guys. I really appreciate the help.
Pin_Head - I think the specs are .004 for the thrust on the idler. That seemed pretty tight to me but I have nothing to base that on. I make sure to check that and do my best to get as close as I can. The face doesn't appear to...
The idler bearings failed on my 3speed tcase. It looks like the gear was slopping around a bit and the rear spacer spun a little against the case.
Is this typical to see some wear on the rear machined face of the case? it doesn't look to be a precision machined face.
What is the...
soft top
Sweet build! Looks sharp.
I have a question about the soft top and the half doors. I was wondering if you have something fancy for door uppers or windows?
Thanks,
awp