Recent content by Anvil

  1. Anvil

    Compressor not turning on

    Thank you Jsloden! I'm going to double check all of the switch jumping. I'll check the voltage on the blue/white wire this time. Thanks again!
  2. Anvil

    Compressor not turning on

    Yes sir, the compressor engages when 12v is applied. I tried ordering a new amplifier. Unfortunately, there is a national backorder on this part. Toyota doesn't know when the part will be in stock. :(
  3. Anvil

    Compressor not turning on

    I finally found time to troubleshoot again... I replaced the round relay, jumped the low pressure switch connector, jumped the thermistor connector, jumped the coolant temp sensor, and still no compressor engaging. Am I correct to assume there are only two components remaining that could be...
  4. Anvil

    Compressor not turning on

    Thanks jsloden and LandCruiserPhil! I truly apprciate your time!! Was your bad relay the round relay, or the rectangle relay that I haven't found yet?
  5. Anvil

    Compressor not turning on

    I finally found time to jump the thermistor plug... Nothing changed, so I guess the thermistor is good. Though I did buy a new one and will replace it soon, just because that's the way I am... Does anyone have a trick to removing the round relay above the evaporator (circled in red)? I wanted...
  6. Anvil

    Compressor not turning on

    Thank you jsloden! I honestly can't thank you guys enough. I truly appreciate everyones time. I'll give that a try tomorrow. I'm determined to figure this out. I failed to mention earlier, I had taken my rig to an ac shop... they were stumped and couldn't fix the problem. Thanks again!! :clap:
  7. Anvil

    Compressor not turning on

    Landcrshr, you were correct! #5 wire has power for a second or two while the starter is engaged. Now I'm back where I started... I've tried two amplifiers with no success.... hmmm...:hmm:
  8. Anvil

    Compressor not turning on

    Thank you landcrshr! I'll test that today.
  9. Anvil

    Compressor not turning on

    I can't thank you enough for your help! :clap: I'll give this a try tomorrow.
  10. Anvil

    Compressor not turning on

    Thank you sir! You've been a big help today. Here's one place I'm cofused (there are many!)... If I read the diagram ciorrectly, it shows the current comes out of the amplifier on #5/black wire. The FSM says there should be 10-14 volts coming in with engine running. #5 is the only wire that...
  11. Anvil

    Compressor not turning on

    Thanks Thanks jsloden! I apologize if I hijacked the thread. It wasn't my intent. I rebuilt my cooling system last year and want it back!! :) So I'm guessing do a continuity check from switch to amplifier connector? I have no CEL light. I welcome ideas/advice! you guys feel free to chime in...
  12. Anvil

    Compressor not turning on

    Can someone please tell me where the switch circled below is located? I used the FSM and volt meter to check the plug going to the amplifier. All was good except this wire. It should be supply 10-14 volts. It has nothing. Thanks!
  13. Anvil

    Compressor not turning on

    Thank you! I currently have the glove out and have easy access! Thanks again!!
  14. Anvil

    Compressor not turning on

    Thank you! I appreciate your time! I'll give this a try this weekend. Cheers!
  15. Anvil

    Compressor not turning on

    THANK YOU!!! I opened the amplifier... the circuit board looked good. I purchased another amplifier from Ebay and installed it. This did not help. So I'm questioning if the amplifier is bad.
Top Bottom