There actually is...check out island Crawler union on Instagram. Although I don't "wheel"...I do fish, and we have to travel through lava fields to get to some spots.
Yes, using Mark's 4L80E transfer case adapter with The Land Cruiser Shop motor mounts and cross member. I going to use the Holley Terminator X Max stand alone ECU for the motor and transmission.
I was actually going to rebuild the 1FZ, but dropping the LS in wasn't going to cost to much more...
Thanks! I was going to use the Delta radius arms, but they're on pre-order until 15 people are on the order list. Last I checked about a month ago there was only 3 people on the list and it's non-refundable.
I am using the delta panhard bracket though. Using the slee kit with slee radius arms...
Thank you!
I don't use 4wd to often and if I have to, it's not for crawling or high speed off-roading.
I don't usually come across trails that put my 80 in a steep articulated angle. But, I guess it's better to be safe than sorry when it does come time to test the suspension angles. 😁
Hi all, still very new to the 80 series.
If I install the part time conversion kit on my vehicle with a 6" lift on it, will I still need/want to install a double cardan drive shaft?
I've been reading forums that people have been installing double cardans up front just for vibration issues at...
Thank for the info bro! Lockers work as it should, sunroof works as well. Checked high and low for rust including where the jack and tools sit, only rust I found was in the driver rear inner fender near the mud flap.
I plan to do all the repairs and rebuilds myself, planning on hitting the...
Sorry maybe you misread something. This LX isn't supercharged, although I wish it was. 😂
Yes I have a plan of attack that I'm working on just not sure if I'm going to just pull the head or pull the entire motor and go through everything. Either way those oil leaks are gonna get taken care of...
Thanks again! I know I've got some work to do, we settled on 10k, and thinking of pulling the trigger on purchasing it. I know I'm going to do the front birfs, and head job along with changing all the problem hoses, as well as flush all fluids to start off this project.
Any other...