bluehawk

Not too much going on with the project. With the help of a friend, been working on the front end and making a crossmember for the grill.

I’ve driven the Cruiser 4k miles this year and everything has been working perfectly! I haven’t done any work to it since June when I reworked my main power circuit and that has been working fine since. I will park it for a bit while I send my...

Do you still have the two front aprons? Price shipped to 37938

First set went to @gedward , sold at the same price Dom was selling them for.

So I bought a set of these from @matzell ,Rob asked if I could make a set of these from Dom’s design. I drew up a set in Autodesk Fusion360 and they are as close to the original design as I could get. This set was cut from 3/16” plate steel...

New U-bolt plates and bump can mounts tacked up. U-bolt plates are double-layered 1/2” steel. The section sticking out is where the bump stop is going to contact. Hopefully doesn’t bend too much, it is 1” thick there.

Anyone interested in any of my signs pictured above? Thinking of making a run of them.

Got the Trans Tunnel Mocked Up

Yeah, "tow truck duty". That's definitely it.

Been a busy summer so its time for some updates, the truck has been a blast to drive. Still haven't maxed out the fuel but other things have been adjusted. I shortened the front driveshaft so I can use 4WD again. Unfortunately there aren't too...

Do you still have the 40 that is being parted out?

thanks sir. Not moving along as much as I want it to, but progress is progress

Looking Good ! Nice work.

Thanks goes out to Austin at AVR Customs for the awesome gas struts and new powder coated brackets. They work awesome

Thanks to @matzell and the “Lynchburg Lemonade” for the inspiration and part numbers for the lift gate cables. Made some mounts and got everything mounted up. Thanks again Rob.

No way i would ever put mine in the dirt :oops: .

Amen to that. I worked really hard to end up with nice paint, and someday I might look forward to doing it again. Until then I intend to wheel it! I get some funny looks when I tell people I’m treating it like Bill Cosby would, depending on what...

No way. Mine has been on the road for a year and people used to say that about it when I first backed it out of the driveway. It now has quite a few rock chips and fade from the engine, and I am okay with that. They are way too much fun to...

My two friends tell me that I’m crazy to wheel this thing after it’s done

I think that you will like your vents on the outer edge of the dashboard. I only have the center vents and the center stays nice and cool but the outside is hot.

Tailgate has been body worked and put in primer

Decided to fill in the two center AC vent holes. I’ll be making a center console with two AC vents and a heater vent in each side of the console.

Not sure it's been 5 years but probably close. She feels real stable at 90mph (passing) though, gotta say, lol.

pretty fun video from our race in Cortez, CO.