Sheck44

Great job Rush ... It's really coming along now

Installed.

This pic that @NikP posted long ago in his build thread helped simplify my approach. Thank you Nik! The other thing that helped was learning about pie cuts. And then I bought the diffuser and cup that J Mack posted, which arrived several weeks...

So she fired off today! I believe there’s an issue between the tune and the cam that will need to be addressed. But it does fire and run - woohoo!!🥳

Few shots from Moab

(Trailer cropped out. 🤣)

Beautiful seats !

Luxury seating

So does the clutch actually get installed, or do you just carry it around in that fancy case? Your new fusible link is your driveshaft.

Ok @bobm , here’s the pics. Made some new frame side brake line mounts with extra space to add 4AN bulkheads for the vent lines coming off the axles. Mounted the little aluminum manifold on the inside of that little sheetmetal strip on the...

You mean 5K under budget, right?

Here’s some pics from the last week. Took some PTO time this week to move this project along. Truck bed coated the fender wells. Beige paint on the top side. Dark gray on the front. Hopefully looks good with the grill the same color. Letting it...

2K primed doghouse, tranny hump, and cowl

VERY close to paint Final decision, this beautiful Toyota cement grey ... should be a great combination IMG_6920 by Steve Heck, on Flickr

Hi Bob, no it's 3D printed plastic that we are using as a mock up. The nest step will be to have the entire thing machined out of billet aluminum and then anodized. Jlawson, not too certain yet what areas will be left aluminum and what areas will...

Original dash face removed and new mock-up installed Hope you guys like !! IMG_3210 2 by Steve Heck, on Flickr IMG_3208 by Steve Heck, on Flickr