65swb45's latest activity

Still available.

Another sold.😉

I think that, regardless, putting an NOS shaft in will cure your problem.😉

LMK how you want to be paid.😊

There's a guy on Ebay who is selling an NOS choke shaft as part of a grouping of carb parts. From Cyprus. Maybe make him an offer for the lot, and I'll buy what you don't need.

Those with a keen eye will notice that Flora Jean is still in the garage. The sniper addition is proving to be a little tricky getting it tuned in. Hopefully I can get that settled soon. The other issue is that the garage is a 7' garage door...

I will take that Shane.

Nice straight Hood spear. All Hardware, good Chrome very light rust underneath. $125 shipped

Good idea, I’ve already made a few parts for him, including rebuilding an entire custom wire harness that took me waay longer then I anticipated! :)

An original 60042 would have had a large hexagonal fitting on the outer face of the vacuum advance diaphragm, with a similar brass fitting that threaded into it, and then a third, smaller fitting that threaded into that. The early 60061 dizzies...

They aren’t any thicker than the metal of the fender itself, so he can just fabricate one from some sheet stock. I’ll bet @cruisermatt could whip one up for you too. And he’s n FL.

This is a new stk Toyota fender. If I look straight down the hole like the stud would go in, it looks like 4" dead center.

Just posted a new story in chat: https://forum.ih8mud.com/threads/the-artful-dodge.1367914/