Very unusual…a great paint job…not!!!! I should also add that everyone is entitled to their own definition of “style”! Let’s just refer to it as unique…very!!
Got out in the garage again today. My next mod is relocating the Sniper coolant temperature sensor to my thermostat housing. I don’t like the block drain location. It was a huge PITA getting it installed there originally because of my headers...
If CruiserMatt is “on it” I’m sure you’ll soon be seeing the best of any after market air injection hose on the market. I was able to source excellent castellated EPDM hose from a few British hose suppliers that was sturdy, durable, rugged and...
You’re absolutely correct,W.
Just didn’t want to “goop-up” the installation with an incompatible thread sealant. Might be likened to perfection personified but doing it right the first time is always the best path of least & lasting resistance.
May need to replace my original upper and lower thermostat housing electrical sensors in the near future. Feel free to correct me, but I thought I remembered, in an ancient MUD post, that applying liquid thread sealer to the sender threads...
5yrs/3000 miles is certainly premature for an inner axle seal failure, particularly on a part-time 4WD setup. Failure modes could be seal failure, inner axle seal groove, damage during install, over-pressure of the differential housing (poor...
That front sway bar is pure DOPE (as in “sick”, “rad” or near “genius”) and from your narrative/ driving experience achieves complete torsion functionality! Dr. Frankenstein is smiling down on you!
Enlighten us further with a few more pics from...
I did not check wheel weights or brakes or any of that last night …
Instead I welded together a jerry can carrier for the roof rack. I’ll be visiting @nakman tonight to get some special Gamiviti mounting hardware to attach it. I got my Gamiviti...
Quality indeed…bought a few for my dual Optima’s many moons ago. These FJ60/62 14ga. SS baby’s are built to last way beyond your Land Cruiser’s last breath!