Bryan062087

Thank you.

Thank you. Will there still be a way to call in?

When will the next one be?

This was before getting the newly installed White Knuckle sliders level.

Interested as well.

Many thank you's to The Rust Famers! Installed a NEW Upper and Lower thermostat housing on the FJ62 today. So happy with the fit and finish! Working my way through a few heater hoses and hope to have the rig back on the road soon!

Do you think if there were slots in the panel that these would allow hot air from the engine bay to escape through the panel and then through the cowl vents? However, if so it could also be pulled in when using the outside air setting for the...

Visited the MD/VA coast.

Waiting to buy the FJ62 fusible link kit. Thank you.

I have a various assortment of transfer case parts (34 mm idler shaft version with vacuum shift). Housing, gearsets, etc. I need these gone ASAP. Pick up in Memphis, TN.

First look and initial test fit. Very impressed by the quality of the sliders.

Absolutely. I will post here in my Cruiser Trash Parts Thread, on Instagram, and on Facebook when they are ready.

Thank you for the update. I'm interested as soon as any are available (1st or 2nd batch).

Any update on the 62 replacements?

Thank you for following up. When did that change? I see a lot of posters here have the 10 degree version.

What angle sliders are these? 10 degree or 0?

Hi, can 10 degree angle sliders be ordered for a 60 series land cruiser?