Has anyone tried to 3D print a disc type thing that has a stepped surface? The back would be slightly larger than the fender hole and the face would be the size of the hole and as deep as the body sheet metal. When glued (?) into place from...
Fan clutches is easy to check. Go out for a drive where you know it will run hot. When you see the temp rise, pull over. Shut the engine off and check the fan for resistance. There should be a significant amount of resistance and if not it’s...
If you get onto trouble post here, there are plenty of good folks that will usually help out. Travel on the weekend and you will have a better chance at getting some help. Some one can bring you a fusable link or alternator.
Enjoy the adventure
Its all compromise
With the bodega where I put it the rear seats do not fold forward. Something the owner does not do.
He came with the bodega and asked for it to be installed.
It was pushed back to make the top as low as possible, its bit...
If you mean the ine at the top for adjusting backlash. I have always just used my fingers to tighten until the bolt does not spin freely and back off a little. Then stake two sides so it doesn't move.
I bought 1 from @Delta VS with the planted seat bracket. Thinking the wife rarely sits in the car and doesn't need an upgraded seat. After a trip and she drove for a little , I have two seats now.
You may use this strategy too. Also...
Things that make it worth it.
Long Drives
Less back pain
Arm Rest
Heated Seats
Flip up seat to access under the seat
Arm Rest
Arrives with zero farts in it
Parts can be easily replaced
Gears don't break
Also give a new seat a good 12 hours...
Just to be clear, I do not sell files.
The installed part was not made or designed by me, I have never shared these files.
@nestor did not install my part, but a copy from some one else. So if it still shakes after installation it may be...