unclegit

this install was cake and it's doing it's job and grabbing oil at a prodigeous rate. What's the most likely cause of high oil catchment - rings / valve seats or valve stem seals ? I'm assuming rings ?

All done. Follow the plan for the spacing on the “Hats” which is what the call the crossbars. You don’t need to drill out the front mount points at all - it just bolts up to the seat mount anchor point you took out in the early stages by the...

Not gonna lie - these instructions suck. So the online document on install gives 2 conflicting spacer sizes for the 80 for hat position A : I assume this is 5 seat vs 7 seat - The paper instructions that came with the drawers agree with the...

When you drill out the holes do you tap them or is it just a washer and nut from the underside of the truck ?