I noticed that without the running boards on my 80, the rear fender flares look like they're "incomplete". I was wondering if anyone has taken it upon themselves to 3D print a set of caps to make the fender flares extend down to the rockers. The idea I have is similar to what some of my fellow Third Gen 4Runner owners have done for their front fender flares. Check out the link below:
FS: 3d Printed SR5 Flare Caps $80 3rd gen - Toyota 4Runner Forum - Largest 4Runner Forum
Does anyone have thoughts on this? I'd love to hear some feedback!
FS: 3d Printed SR5 Flare Caps $80 3rd gen - Toyota 4Runner Forum - Largest 4Runner Forum
Does anyone have thoughts on this? I'd love to hear some feedback!