SOLD WTS Marks Bell Housing Adaptor (1 Viewer)

[newmexicokid]

Vehicle Model

1. 40 Series
2. 60 Series

Location

Gallup, New Mexico United States

Catch and release from a few years ago. I will take $600 plus shipping for it. Here is the original ad I responded to all those many years ago. Below are pictures of it now. I ended up going a different direction with my build and now its time to start unloading all the unused parts in my life.

SOLD - Marks sbc adapter

Good condition, this is for the adapter,spud shaft, Throw out bearing and fork. The 4spd and bellhousing are not included . This is a great way to put a sbc in a 40, or 60 series as it moves the engine foward and the trans/transfer can be left in its factory location, no driveline alterations...

forum.ih8mud.com

 

[newmexicokid]

More Pics

 

[newmexicokid]

Bump

 

[newmexicokid]

Bump

 

[newmexicokid]

Bump

 

[Downey]

What is the over-all length of the spud shaft from tip to tip???

 

[newmexicokid]

Bump

 

[newmexicokid]

What is the over-all length of the spud shaft from tip to tip???

Sorry for being so slow on this. It was in a box in my other warehouse and It seemed like I could never get up there. Here's a picture of the spud shaft. Its about 7 5/8 or the metric equivalent.

 

[newmexicokid]

Bump

 

[Downey]

Thanks newmexicokid, I have the complete adapter minus that shaft, I have to make the shaft since Marks & AA want $800.00 for a new shaft, and I have the ability to manufacture a new shaft for far less than that. I already have the male splined end (cut from a tranny input shaft) and the female splined piece (taken from a clutch disc center hub). I will merely shaft/sleeve then into a 7 5/8" long piece, weld, then have my local heat treater normalize the completed shaft.

 

[AlaskaOverland]

PM sent