Who does metal fabrication?

[secretasiansam]

Who local is doing metal fab? I want to add a hitch reciever to my old trail tailor rear bumper. I don't want to tow, it will be used to hold an RTIC 65 and a couple jerry cans. Was planning on adding a fridge but can't afford that right now. I'm out of room with two 75lb digs and two kids. Thanks!

 

[ttFJC]

I sent you a dm

 

[secretasiansam]

I sent you a dm

Thanks!

 

[AirheadNut]

I've been setting up a small fabrication shop over the last year, would certainly be willing to take a look at what you want done. Been fabricating as a hobby and for work for a number of years now.
A couple of examples of past projects:

 

[MTMarcoux]

Who local is doing metal fab? I want to add a hitch reciever to my old trail tailor rear bumper. I don't want to tow, it will be used to hold an RTIC 65 and a couple jerry cans. Was planning on adding a fridge but can't afford that right now. I'm out of room with two 75lb digs and two kids. Thanks!

I can also give a hand if needed. I am a machinist by trade but have always been into fab work. My most resent project was a custom rear bumber with a swing out for the 4runner. The hitch I installed has not been load tested but Ive been hauling bikes on it for a year with no issues

 

[secretasiansam]

Thanks, I'll be in touch with someone soon.