What's your Ironman 4x4 bumper experience? (1 Viewer)

[mrlittlejeans]

Tires look good. 285 70 r17?

295/70r17

Removed front mudflaps and had to do a little heat gun work on the front liners but it was minimal.

 

[linuxgod]

If there is enough interest, I can get some made. I would need someone to get me dimensions and material properties though.

You can use this as a template and put in the correct dimensions.
View attachment 3438379

I took some measurements and the rough dimensions are in red below. I wouldn't fabricate based on these, but they should get you close. The frame hole is about 3/4" tall and a hair under 1.25" wide; however the frame hole is also slightly rounded in the corners so you'll either need to use a slightly smaller block (like I measure below) or else grind the corners of the hole to square it up.

I measured because I'm thinking about making my own and needed to know what size blocks of steel or aluminum I'd want to start with. Steel is probably better for this but aluminum is so much easier to grind and tap.