Hopefully located the source of my mystery noise this afternoon, this ball joint looking thing is actually broke, I just wedged it back between for the photo. Thanks!
What's this part? (ID help)
- Thread starter SuperBrett
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #3
The vertical bolt that goes through the sway bar. This is the front drivers side, BTW.
Sway bar end link
Easy fix. Those seem to rust pretty bad. Not noticeable until you remove them.
- Thread starter
- #6
Thanks everyone. Doesn't look too hard to replace, off to autozone it is!
If you are putting in a new sway bar end link, I highly recommend replacing the rubber cushions as well. And of course, if you are doing one side, you should do both. Plus, it will ride better. I forget if they come with new nuts, but I believe they are lock nuts and not sure if they are reusable, so I also recommend new nuts.
Sent from my GT-N5110
Sent from my GT-N5110
Both of the sway bar end links were rusted through on my 100. I replaced both with TRW assemblies. The assembly included the link, cushions (top and bottom), washer and nut. Everything you need for a easy 5 minute installation.
- Thread starter
- #9
That sounds right up my alley, quick question though.....what is TRW?
TRW is an aftermarket parts supplier. I picked these up from Amazon.
Amazon.com: TRW Automotive JTS847 Premium Stabilizer Link: Automotive