Well I got me a BJ 74 - let the work begin

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Was asked about the Bullbar in the other thread. It was off a HJ75 Ute and would have been a straight bolt on if I didn't want to keep the Factory PTO. To get it to fit I basically cut out the centre of the bull bar and welded in the PTO cradle.

 
Well I made a start on the brush bars and side step yesterday. Should get them finished today with some luck.

Have done with 4 chassis mount points and a front bar sleeve. I usually clamp to the front bars but the TJM Bullbars have a sloping upright, unlike the ARB's. That means you can't get a clamp to fit.

 
Nice rig !
 

Users who are viewing this thread

Back
Top Bottom