Water dripping inside under glovebox?

[TexusLexus]

Seems like my AC is condensation line is dripping inside the car. It’s coming from under the glove box on the passenger side floorboard. Not very much. Maybe 5 or so drops and hour. Anyone have any experience with this?

 

[rexington14]

Yup, common issue. There's a foam gasket in there that has deteriorated. Open it up (7 or so screws), pull out gasket, clean the area (will be full of leaves, dirt, etc) and replace with new gasket.

On my 05 LC, part # 88578-47040

 

[kevgentile]

Clear out the drain too

 

[TexusLexus]

Yup, common issue. There's a foam gasket in there that has deteriorated. Open it up (7 or so screws), pull out gasket, clean the area (will be full of leaves, dirt, etc) and replace with new gasket.

On my 05 LC, part # 88578-47040

Much appreciated! Wife and I are an anniversary road trip and I told her someone on here would know the answer haha!

 

[Exiled]

Would anyone know the part number for a new gasket, but for a 98-00? Thanks in advance, I just recently had this issue pop up.

 

[Exiled]

Would anyone know the part number for a new gasket, but for a 98-00? Thanks in advance, I just recently had this issue pop up.

Never mind, I figured it out, it's the same part and I just ordered it. Thanks again!

 

[take123]

I have this problem. Your seal at the bottom of the evap cover needs to be replaced.

I just did mine.

Resealing the Evaporator Cover

I've got a small drip from the evaporator cover on the passenger floorboard. I pulled the cover off of it the other day and cleaned out the box (it was filthy dirty) and blew some compressed air up the ac drain line. I thought that had fixed it, but apparently not. So now I've got the cover...

forum.ih8mud.com

I also replaced the COVER with a proper Lexus one that has a slot for air filters, the Land Cruiser for some reason (at least my 06) does'nt have air filters.... But the LX ones do have so I got that cover.

 

[mintyfresh]

I removed the glove box and the 2-3 screws I could see from the black cover but couldn't get it loose. Any ideas?

Thank you!

 

[terryscott621]

I removed the glove box and the 2-3 screws I could see from the black cover but couldn't get it loose. Any ideas?

Thank you!