Want To Borrow Clutch Alignment Tool (1 Viewer)

[meatloaf]

Does anyone, preferably south, have a 10-spline clutch alignment tool I can borrow. I need to use for the 4-speed/3FE combo. I can order one online but it will be till next week before it comes in

 

[meatloaf]

Found one…

 

[meatloaf]

So I lied…. The tool I borrowed was not for Toyota, the splines fit ok on clutch disc but the tip was too wide for pilot bearing.

So does anyone in So. Austin have one I can borrow?

 

[davegonz]

Is it the same spline count that's on an H55? If so, ask @bottombracket . Galen might have something that would work.

 

[bottombracket]

Luis, let me check if I have a 10 spline tool.

 

[bottombracket]

Got one for ya.

I’ll ping you offline.

 

[meatloaf]

Is it the same spline count that's on an H55? If so, ask @bottombracket . Galen might have something that would work.

Got one for ya.
View attachment 3320431

I’ll ping you offline.

Thanks Dave, Galen hooked me up

 

[davegonz]

Is your 40 project finally going to be on the road?

 

[meatloaf]

That’s the plan, I resealed the 3FE and started mating engine to tranny/tc. Still have a lot of work before it is road worthy but it has sat too long already