Stuck crankshaft seal (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 31, 2013
Threads
4
Messages
20
Location
texas
Little help required. While replacing the seal, I broke it and left the outer diameter pressed against block body. Any suggestions on how best to remove it? Read that drilling small hole and drive a screw I can remove it but since I have not done this on this 93 before I am not 100% sure this is safe. Looked for a picture that showed the profile cut away of thw assembled motor but it is not clear if safe. Appreciate any input

1419406247431.jpg
 

Users who are viewing this thread

Back
Top Bottom