Smashed winch controller

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 15, 2010
Threads
24
Messages
189
So I finished up surfing today and some foolish guys decided to drive a 2wd Yukon with 20" rims onto the beach. They talked some guys into linking trucks up and pulling them out, then promptly buried themselves up to the axle again.
It was about 35 degrees out with a strong windchill and getting dark so after lending them my tow strap and watching them destroy it I decided to winch them out of the sand.
It was pretty dark and I had to move from the front to the back of their truck and when we were almost done my winch stopped working.
The warn winch controller cable got looped funny in the dark and got smashed in the tightening cable. I cut the controller cable and spliced the wires but it still doesn't work.
I'm wondering if the cable being smashed could have messed up the controller? Or did I damage my winch? I'm hoping I can just buy a new warn winch controller and tow strap and call it a lesson learned, but I would be pretty disappointed if I damaged my nice winch!
Let me know if you guys have any thoughts or have experienced this.
On the upside I was really impressed with how well the warn pulled the Yukon out of the deep sand, and after the winch stopped working I put my 80 in 4 low and pulled it right out easy.
 
What kind of Warn winch do you have?
 
It says m26626 on the winch motor so is that a 9000 xd?
 
Well I used the other winch controller I had, and it didn't work.
So I'm wondering if that controller wire being smashed shorted out something on the winch, or if I burned up the motor on the winch or what?
 
Found the problem, it just shorted out a wire in the controller box on the winch, stripped the wires back, cleaned them up and shrink wrapped them and spliced it together and it works great now!

image.jpeg
 

Users who are viewing this thread

Back
Top Bottom