sliders without steps for 2000 100 series

[chuckscap]

Hi I've looked at most of the slider threads still haven't seen anything I like. I'm really looking for something with a minimal profile that provides decent protection. I've looked at Slee, MetalTech, White Knuckle and Bio so far.

 

[Keowee]

www.rocky-road.com

 

[hoser]

Perhaps LCPhil's:

https://forum.ih8mud.com/threads/fe...-clearance-low-cost-rock-rail-sliders.801312/

If not, White Knuckle, BIO and CruisinOffroad all do custom work.

 

[chuckscap]

Thanks! Went fly fishing on the South Platte today, used my running boards to get my waders off. Maybe I will go with the Slee sliders!

 

[drwapenshaw]

Good info on sliders! Thanks to all!

 

[chuckscap]

Doing more searching on Mud, I found these Bump it off road sliders. I think this is what I'm looking for. Any feedback on their quality?

https://forum.ih8mud.com/threads/bump-it-offroad-bio-sliders.820450/#post-9397449

 

[krice118]

from everything I have read, and a little emailing with Mike from BIOR- Quality is top notch and his customer service is great as well.

 

[Hayes]

Mike at BIOR did some custom sliders for me. Excellent build quality. FYI I had him build a set without the rear bumpout, which may be the more subtle profile you're looking for (?)

Doing more searching on Mud, I found these Bump it off road sliders. I think this is what I'm looking for. Any feedback on their quality?

https://forum.ih8mud.com/threads/bump-it-offroad-bio-sliders.820450/#post-9397449

 

[Hayes]

Mike at BIOR did some custom sliders for me. Excellent build quality. FYI I had him build a set without the rear bumpout, which may be the more subtle profile you're looking for (?)

Doh.
Just noticed that was my slider thread you linked.
Yes. Excellent quality. Excellent sevice. The sliders have felt rock a few times now, and have done their job.

 

[chuckscap]

Doh.
Just noticed that was my slider thread you linked.
Yes. Excellent quality. Excellent sevice. The sliders have felt rock a few times now, and have done their job.

Thanks much! I'll be calling Mike and sending him the photo of your sliders. First to get my AHC ripped out and the OME 1.5" lift kit put in mid June, then sliders. Then I plan to get out and enjoy my Hundy up in the mountains.

Thanks again,

 

[chuckscap]

Doh.
Just noticed that was my slider thread you linked.
Yes. Excellent quality. Excellent sevice. The sliders have felt rock a few times now, and have done their job.

Already contacted Mike via email, will call him. Ryan how much is your 100 lifted? It looks great!

 

[Hayes]

Already contacted Mike via email, will call him. Ryan how much is your 100 lifted? It looks great!

Thanks. I'm running the OME heavy rear coils with the OME torsion bars set to match. Can't remember my hub to fender distance, but it's around a 2 to 2.5" lift.