Anyone know the rough measurements from fender edge to wheel center for a stock, 2" and 4" lift? I know these will vary but is there a general ballpark for each spring lift setup (stock body)? Anyone know the stock dimension?
Rough dimensions for various lifts?
- Thread starter Gusb
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
On my stock 71 with uncut fenders and stock, origional saggy springs: front is about 20 3/4", rear is about 17 3/4"
Well on my 42 with a 2.5" and 33's im at exactly 37" ground to rear edge if this helps at all
