Replacing hub assy. Problems! (1 Viewer)

[lgrt]

there is a good pic here (FJ Cruiser half shaft replacement) that shows how the seal should sit when you have in correctly. Good luck.

 

[Skvlldvggery]

They ordered the wrong part. Figures dealing with Toyota.

 

[Skvlldvggery]

there is a good pic here (FJ Cruiser half shaft replacement) that shows how the seal should sit when you have in correctly. Good luck.

Thanks for the picture! I think mine is definitely bent. I'll have to wait a couple more days to get the part. They'll have to reorder.

90304-83001

I think that's the part # for the dust seal.


That part # is incorrect. ---update---

 

[lgrt]

for our 4WD 2007 FJC, the Steering Knuckle Oil Seal part # was marked as 90316-A0001 on the package from my Toyota dealer.

 

[Skvlldvggery]

I've got the oil seal. I need the dust shield that goes on the end of the cv axle. Toyota ordered the wrong part again. Now they say they cannot help. Wtf? So I have to buy a cv axle to get the dust shield?

 

[Skvlldvggery]

Looks I'm taking your advice and beating it back into shape. Hahaha

 

[Skvlldvggery]

Ok so that fixed the problem as far as I can tell. When I was tapping the flange I must have bent it a little out of shape cause it was a bitch to get seated back on the axle. I drove it down the road and I didn't hear any grinding or metal to metal noises. Only time will tell.

So either you buy a new half shaft to get the dust shield or try to order it online. Dealerships and parts stores DO NOT carry this part separately. And any doing this repair on a hub assembly, watch that your axle isn't pulling through with hub or your end up like me with bent parts!!!

Thanks for the guys that helped me out I do appreciate your time!!!

 

[lgrt]

glad to hear you got through it and are back on the road. Nice work