OK, was checking to see if my rearmost windows are leaking or not. Looked good. Incidentally, the seal system in there is pretty good, there are several drains from the rubber channels that the windows slides on. Nicely done.
One exception, though: On the rearmost vertical section (the very back of the sliding window), the rubber seal shows a pretty good size gap, something like 1/8" or so, just about right in the middle. This on both DS and PS. Apparently, this is where the seal ends were or should be joined. Perhaps the rubber shrank as I can't believe this is original. Does not look like this may contribute to a big leak, but seems like there may be water coming in and making things wet under the rubber. Especially since it's in the very back and any rain would get blown that way into the crack. That would not be good.
Anybody else sees that?
Looked into it?
Needs sealing up?
Eric
One exception, though: On the rearmost vertical section (the very back of the sliding window), the rubber seal shows a pretty good size gap, something like 1/8" or so, just about right in the middle. This on both DS and PS. Apparently, this is where the seal ends were or should be joined. Perhaps the rubber shrank as I can't believe this is original. Does not look like this may contribute to a big leak, but seems like there may be water coming in and making things wet under the rubber. Especially since it's in the very back and any rain would get blown that way into the crack. That would not be good.
Anybody else sees that?
Looked into it?
Needs sealing up?
Eric