Has anyone replaced/ built there own rear fixed spring hangers? I want to replace these on mine I have repaired both sides once and think it's time for something a bit beefier. it's the non-shackle side of the rear spring.
Rear fixed spring hanger on a 40
- Thread starter sandj527
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I just finished mine. Made them out of some 3/8 angle and plate. The hardest part was getting everything squared up under the frame. There's few angles going on there.
I think Proffitts, Ruffstuff, etc makes aftermarket ones.
I'll try to get a picture for you.
I think Proffitts, Ruffstuff, etc makes aftermarket ones.
I'll try to get a picture for you.
- Thread starter
- #3
Pics would be awesome
I've got 'em tacked on for now. I've learned to never weld anything up until I'm 100% satisfied with it. I still need to gusset it. Not sure whether to fully box or just do plain triangle ones. They're not pretty, but they were basically free. 
- Thread starter
- #5
Those look pretty good. Did you put the plate on frame rail?
Yes. I had a set all welded up with gussets and painted, then had to cut it all back off. That's why the scab plates have a little surface rust.
