Quik Hinges available (3 Viewers)

[69LC]

Ready to buy when back in production.

Ready to ship

Curious what folks are doing for door limits when using quick hinges? I have a couple sets I plan to deploy this summer, but curious what folks are doing that fits the "quick change" mantra.

I’m not familiar with the later thick door limiters, but the early thin door trucks have a retaining pin that just slips out.

 

[69LC]

I'd like a set for two doors (super set?) when you have them back in stock!

I have enough for 7 Regular Sets or 3 Super Sets and one Regular Set.

More to come!

 

[CruisinGA]

Just ordered a regular set from the site at mc designs offroad - http://www.mcdesignsoffroad.com/, looking forward to being able to easily swap doors on and off in the fall as things cool off... and then warm back up....and cool off again!

thanks @69LC

 

[69LC]

Thank you for the order!

 

[69LC]

@CruisinGA tried ordering earlier and we found another glitch with my site.

We got the order done via PayPal, but I was also able to get my site fixed to work as it should.

 

[69LC]

Whelp, the website works! Just got a Regular Set sent off to NorCal.

 

[69LC]

I’m back from my wife’s bday camping trip and am ready to ship as ordered.

Matthew

 

[gmr76]

Finally (after having them for a few years) installed mine this past weekend. Not as bad as some posts make the install seem. I did remove the gauge cluster and light switch and went that route for the upper drivers hinge. Was pretty simple after that. Just a little tight to get the bolts started.

I did have to work a bit to get it the door side adjusted so I could remove them without loosing the bolts. Any tips here? I’m guessing I’ll have the same issue when I mount my regular doors at the end of the summer. That was actually the worst part of the install (but they I can remove them without too much binding). Would definitely recommend if you remove your doors and don’t want to mess with banging out the hinge pins every time!

 

[69LC]

Thanks for posting @gmr76. I would recommend installing the hard doors first and setting the hinges to the body with them and then adjust any second or more sets to the initial setting.

Matthew

 

[69LC]

I think I might have sent my first ever order to Saskatchewan today.

 

[69LC]

I have lots of parts ready to assemble for any type of set.

Great projects for fall and winter wrenching!