PHH replacement cost?

[NCLX450]

Looks like the PHH is leaking and I'm planning to replace it with the silicon kit. Unfortunately I don't really have the time or patience to deal with it now. What kind of cost am I looking at and any good suggestions on who to trust around the Winston-Salem area for the work?

Thanks!

 

[lumbee1]

It's not that bad if you do it yourself. My arms were sore for reaching into such a small area. I also used Gates Green Stripe with constrant pressure clamps.

 

[stevezero]

Gates green stripe or napa yellow stripe hose, and breeze constant torque clamps. You can do either the short piece, or bypass it and the hardline up to the heater control valve. I did the bypass on both of my 80s, and have enough hose to bypass the heater control valve and both heater cores if i had to.

 

[NCLX450]

If I have time this weekend I will get under it and see if I can get it done. Normally I'm all in to do everything myself but part of me says screw it and let somebody else get it done.

 

[stevezero]

Remove the starter and youll gain a little more room To work. also the plastic inner fender flap on the drivers side