Parting out a 85 FJ60

[arcteryx]

Location

United States

Email me at jason at cruiseryard {dot} com or PM me.

Located in Austin. Picked up an 85 FJ60 that is originally from Colorado, so it;s very solid with 2 rust areas that I have stated below.

• The engine runs strong, about 190K. I was going to use it for my 40, but will use the one from my 87 FJ60.
• It's gray/gray
• I have a spare DS seat that is unripped
• I have all of the body parts to repair the front corner
• I also have extra doors.
• The PS rear quarter panel is from scrape and has surface rust from no paint. It doesnt have the typical rear quarter panel rust, so I can cut those out
• The only place I have seen rust is on the very bottom of the tailgate (which isnt that bad) and the rear inside frame rail.

Full set of pics- 1985 FJ60 - a set on Flickr

Some are below

 

[LAMBCRUSHER]

does the H42 have the spacer?

 

[KruiserK]

hood

How is the hood? Is that the same gray as the 62? How much to 11211?

 

[tat2matt]

email sent

 

[87CRUSR]

Dashpad interest

Email sent. Thank you.

 

[Finnyfam60]

pigtail wires that come off the windshield wiper motor? (only about 6 inches long, has white round connectors on both ends with black fusible link / capacitor thingy on two of the wires...)

 

[TRAIL TAILOR]

Rear carpet and tailgate carpet to 82935.. Also, front passenger side fender?

 

[baxter650]

How is the front carpet? to 98295

 

[arcteryx]

will get some pics of the carpet this weekend. stay tuned.

 

[redcorn]

Interested in four doors and possibly tailgate and hatch.

Shipping ?

 

[LAMBCRUSHER]

taillight lenses and transmission shifter tunnel hatch and shifter boot to 93614? TIA

 

[arcteryx]

Carpet and more pics uploaded. The front carpet is pretty good, the rear is frayed in the back.

 

[haddix]

How much for tailgate and hatch? Pics to haddix287@yahoo.com if possible. Thanks

 

[jaxonm]

PM sent

 

[wardfoto]

I need the brake line connection that sits on the passengers side frame rail. The piece the two brake lines go into from the master, that turns the fluid to the front and back.

*edit- I could also use the ebrake handle assembly. Let me know! Thanks!

 

[roma042987]

p/s pump, bracket, line. shipped to 35811

 

[arcteryx]

more pics uploaded, including doors

 

[VETTE60]

need front diriveshaft, aisin hubs, heater control vale from engine bay. pm me. thx

 

[arcteryx]

to the top

 

[Finnyfam60]

Wiring loom off of the windshield wiper motor? (no cutting involved, I only need the small section between the two large white connectors)