Parting another FJ60 northeast PA

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 20, 2003
Threads
2,288
Messages
7,857
Location
NE PA coal region
Got in another FJ60 this weekend. Wheelwell rust and rusty rear shock mount crossmember the only problems I can see. This truck runs and drives very well. IN any event I'm gonna part it out, the transfer case and power steering box are spoken for but other than that everything else is available. This is an unmolsetd truck, bone stock down to the original radio (plays quite well as a matter of fact) and spare tire. Red truck with gray interior.

Engine runs great, sounds good doesn't smoke at all that I can see and starts fine even without the choke. Will do a compression check for a serious buyer. engine will be sold complete with alternator, water pump and clutch fan unit, bellhousing and clutch assembly, electronic distributor (still has the rubber boot buttoned around it), complete intake manifold, carb and air cleaner, exhaust manifold. I'll also include the smog pump and all the smog equipment, remember this is an unmolested truck and all the smog gear as far as I can tell is still in place and working. Price $650 you can come hear it run.

This engine has the bolt holes for mounting the factory power steering pump and bracket of course. I can sell the PS pump and bracket for $75or leave it on the engineprice of the engine with PS setup $700.

Other items:
4 speed tranny works fine $50 Gear drive starter $45
Third members 3.70 ratio $50 each Either driveshaft $20
Steering knuckle either side these are the big stud knuckles $50 each
Birfields with outer axle $50 each Inner axles either long or short $20 each
Complete exhaust system- brand new tailpipe and muffler cat looks good $75 pickup only Aisin hubs the good ones nice shape $85 the pair
Nice gray dash pad $75 buyer needs to suggest how to ship
Front end- nice fenders, hood and grille- some rust at bottoms of fenders but this is a pretty decent front end- $175 the works Windshield $40
Bumpers- no rust through- some discoloration- rubber ends intact $55 each
Original AM/FM radio plays well good knobs!!!! $75
Doors- no rust through that I can see. There are some dents but these are better than most FJ60 doors I see. $45 each
Tailgate (lower) no rust thgrough $60 Nice gray steering wheel $20
Upper hatch no rust through but not perfect $50
Set of Gabriel premium gas shocks less than 500 miles on them $60
AC compressor- this truck has cold AC $45 condenser $20 pickup only
Radiator truck doesn't overheat no coolant leaks $25 pickup only
Rear tail light assemblies original Toyota not the faded aftermarket $35 each
Stock chrome wheels with tires with good tread $75 the set of four

Ask for anything you don't see. Parts located northeast PA near Paragon and Rausch Creek offorad parks. I would prefer to not ship the bigger parts but will if necessary. I can shrink wrap the engine to a pallet and have it ready for pickup at the receiving dock where I work if buyer makles payment and pickup arrangements. Hit me offlist shmukter@pa.metrocast.net or call 570-668-2489 before 8PM eastern time. Thanks, Shmukster
 
Do you have the carpets? what condition are they in?

Thanks.
 
What year is it? Thx Dave
 
What color is the interior? Looking for the grey/blue dash pad.

Thanks
 
sent ya a PM abt the aisin hubs...


malphrus
 
Interested in the PS pump and bracket. Would you ship to Canada? (Ontario)

Thanks
 
Do you have backing plates for the front? Not rusty, though, I've got a set like that already. Thanks.
 
FJ60 is a 1987

Sorry 'bout not listing the year truck is an 87. Sent PM's to everyone who had a question. Shmukster
 
shmukster said:
Sorry 'bout not listing the year truck is an 87. Sent PM's to everyone who had a question. Shmukster

I didn't get a PM... asking about backing plates for the front.
 
I need a nice hood liner and license plate lamp assembly. Also a brown cargo and tailgate carpet if you have it. PM me a price shipped to 46220. Thanks.
 
That would be the license plate lamp assembly.
 

Users who are viewing this thread

Back
Top Bottom