Parting Out parting 77 fj 40

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Do you still have the hardtop? I am in desperate need of one. Looking for one at a reasonable price. Not too sure about shipping though. Would prob have to be by truck to 76354.

I do still have it. No doors. Is in great shape. The raingutter is not rotted at all. Give me a call, 845-367-2054
 
How about the splash pan under the radiator, it has a dished out area for the front pulley. I want one in really good condition. Also I could use a workable front turn signal (Drivers side) as a friend broke mine helping pull engine head....also the tail light assembly's if they are in working order.

Thanks
Dwight
 
Looking for
  • Both shifter boots
  • Drivers side tail lens
  • Rear ambulance door striker plate. The thing on the floor that the rear door latches too when shut.
  • Windshield wiper squirter. This is specific to late models where it is mounted in the top of the windshield frame
  • Rear emblems, 4 Wheel Drive and Toyota.
  • 2 upper ambulance door hinges
 
Thermostat housing

I'm looking for a thermostat housing (top and bottom) for a California 9/1977 2F with an oil cooler. Do you have one availble?
If he doesn't have the housings-check w/ Mark's Off Road--he does.
 
Looking for
  • Both shifter boots
  • Drivers side tail lens
  • Rear ambulance door striker plate. The thing on the floor that the rear door latches too when shut.
  • Windshield wiper squirter. This is specific to late models where it is mounted in the top of the windshield frame
  • Rear emblems, 4 Wheel Drive and Toyota.
  • 2 upper ambulance door hinges
I think I have a used bottom striker--will look in the box---
 
Looking for the gas pedal assembly and all the linkage up to the carburetor. If you have them, price to Vancouver Wa. 98682.

Thanks,

Jeff
 
Looking for a front drive shaft. Shipping to PA, 17601?

parting out a severly rusted 77 fj-40. Still has good parts though. Complete drivetrain available ($400). Wiring harness ($50) good and push pull knobs with switches (fan, headlight, cigarette lighter). All five stock wheels good ($150). Hard top is in good shape. Will need doors though. Dash pad is ok, cracks on corners not bad though ($75). Let me know what you need. Call, it is easier, 845 367 2054, Dan.

Update parts list:

Complete 2F - unknown history - SOLD
4 speed trans and transfer - shifts tight - SOLD
Dash pad ok shape - SOLD
All lower dash pads - SOLD
windshield washer bottle with motor
Over flow tank - SOLD
5 Stock wheels - SOLD
Steering wheel
windshield frame and gasket
Glove box door - SOLD
Ash tray - SOLD
E-brake cable - SOLD
Speedo cable - SOLD
2 front drive shafts
rear drive shaft
Complete front disc axle - will need backing plates and gone through.
Skid Plate
Hard top
2 dizzy's - SOLD
Aisan Carb - SOLD
front heater
 
Are you willing to cut a section of the firewall where the brake booster, clutch and steering column are? I'd give you $100 for it? Send a picture if you're interested...
Thanks
 
This post is 4 years old guys...guy hasn't been on MUD since June.
 
Back
Top Bottom