Needing a passanger side knuckle arm

[sandj527]

I was putting on some new tie rod ends when i discovered that my passanger side knuckle arm has a crack in it. Does anyone have one that will fit a 1977 fj40? Does anyone know if it can be welded?

 

[Bossman]

I've seen folks weld them without issues on trail trucks but not sure I'd trust it on one that sees street use. I should have one though. Do two things for me - just measure the distance from stud center to stud center as close as you can to confirm the one I send you is the right size and pm me your address and I'll get one in the mail to you.

 

[sandj527]

I will get right on that. Let me know what you want for it and shipping to 72764. I can paypal you or send you check/money order. What ever payment you prefer. From what I have seen on the web used ones are $40-50 bucks.

 

[Bossman]

If it's the small bolt pattern that I think it is I don't need anything for it. Should have several from past builds. Happy to help a brother out.

 

[79coyotefrg]

if one from a mini truck will work i'll give it to ya if you come to the April 9th event at Superlift

 

[YotaJosh]

if one from a mini truck will work i'll give it to ya if you come to the April 9th event at Superlift

Tie rod hole size is different. LC TRE's are smaller. You can use a bronze starter bushing to make a LC TRE work with a mini truck arm though.

I have access to one from a 74 drum brake axle that uses small pattern arms if you need it.

 

[sandj527]

Thanks guys wanabecruisen has one on the way. Planning on coming to the April event though.