Anyone have one? My Amazon one can’t hold it and I’m afraid I’ll break something. It’s a 4.7l ‘04 4runner. Halfway through a timing belt change. 
happy new year btw!
happy new year btw!
Need a crank pulley holder.
- Thread starter emoto
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Mauser
Supporting Vendor
Taking the bolt out? Put a breaker bar on it, put the end.of the breaker bar on a floor jack, bump starter.
- Thread starter
- #3
Affirmative. What about torquing back down?
ramangain
Clarksonian disciple
Do you have an appropriate torque wrench?
- Thread starter
- #5
yessir, the touch start method worked like a charm
Not sure about a 4runner, but on mine you can put a deep-well impact socket on one of the flexplate bolts, which gets wedged up against the bellhousing, then torque down the pulley.
If you have the tools, it also isn't hard to make a holder out of scrap. You could borrow the one I made but I'm not sure if the bolt pattern on the pulley would line up between a land cruiser and a 4runner.
If you have the tools, it also isn't hard to make a holder out of scrap. You could borrow the one I made but I'm not sure if the bolt pattern on the pulley would line up between a land cruiser and a 4runner.
Last edited:
Mauser
Supporting Vendor
@emoto did you get it? If you need one I could build you a tool like @WCBlueSky built.
- Thread starter
- #8
Man, thanks for that offer. I broke down and ordered the tool. Hopefully someone else can use it around here.
