- Location
- United States
Just purchased a pre-welded Metal Tech Family Roll Cage for $900.00, and It just won't work with my original bench front seats, nor my rear jump seats. It is a kit, with the dash cross bar - middle cross bar - two upper tubes over driver/passenger, two upper tubes over rear passenger area - grab handles lower and top - down tubes from middle pillar to front pillar (down along doors), and front seat cradle. The guy I bought it from said it would work with rear jump seats - however it does not - since mine are the longer versions. Also, the cradle is too narrow to fit original bench seats in front - so, I either sell this cage to someone who can use it, or I butcher it and make it try to work. I'm making decisions quickly, so if you are interested - yell at me!
No pics yet - have it sitting in garage after using a tractor to lift it in place, and then take it out. Look up Metal Tech 4x4 and then take a look at their kits - it's the most complete one : ) I will sell for what I paid for it - $900.00
Thanks!
Todd
No pics yet - have it sitting in garage after using a tractor to lift it in place, and then take it out. Look up Metal Tech 4x4 and then take a look at their kits - it's the most complete one : ) I will sell for what I paid for it - $900.00
Thanks!
Todd
