What is the shape of the inside of the casting that the spring loaded, rotating lunette mounts into?
Is it just a double cone shape?
I'm thinking of taking a piece of 2"x2" bar stock & having it machined to accept the M416 type lunette & shaft.
Then mounting that onto 2x2 single trailer tongue.
Does that make sense?
Edit: after a bit more research it might be simpler to take the receiver casting & mill off the angled sides & bottom flat & mount that onto the trailer tongue.
I've looked but can't find pics of the cast receiver part bare from the side.
Anyone have or know where I can see some pics?
Allen
Is it just a double cone shape?
I'm thinking of taking a piece of 2"x2" bar stock & having it machined to accept the M416 type lunette & shaft.
Then mounting that onto 2x2 single trailer tongue.
Does that make sense?
Edit: after a bit more research it might be simpler to take the receiver casting & mill off the angled sides & bottom flat & mount that onto the trailer tongue.
I've looked but can't find pics of the cast receiver part bare from the side.
Anyone have or know where I can see some pics?
Allen
Last edited: